Newest asmodus squnok vape kit spruzza 80w, include spruzza 80w vape mod and Fonte 24mm RDA.three classic colors available. the spruzza regulated squonk vape mod powered by 1pc 18650 battery and max output 80watts, with innovative and beautiful design, the spruzza is built around our own pump design, which has dubbed the SSS(smart siphon system).instead of squeezing an exposed bottle. vapers only to feed juice into the RDA is pull down on the lever located on the side of the device. the SSS has a whopping 6ml juice capacity and can be easily filled by sliding up the glass door of the tank. the pre-primed the pump system at the factory using VG for the easiest operation possible, and cleaning the tank is done by flushing out the pump with VG, no disassembly required. the spruzza is powered by a GX-80-HUT chip which allows for VW and TC, TFR, TCR and wattage curve mode. curve allows the user to imitate the experience of temperature control mode by allowing the user to set five different wattages setting combined with 5 times presets up to max of 10S.for example if you were running a Clapton style coil, which typically requires a little ramping to get to a firing sweet spot,vapers can set the device to fire at 80W for 0.2S and then 65W for 5S.the font RDA focused on flavor,the deck of the RDA is simple two post design with side-mounted screws,making it easy to build on,and the juice well has a convex shape that makes juice flow to the walls, where it will be absorbed by your wicks,asmodus machined the side airflow inlets at a downward angle to simulate a bottom-airflow design for improved flavor, which is enhanced by the conical top cap and wide bore drip tip, the large heat sink on the top cap will help to get rid of excess heat.
- Material: zinc alloy + stabilized
- Battery: 1pc 18650(sold separately)
- Large 0.91inch OLED capacitive screen
- Output wattage: 5-80W(VW)/5-60W(TC)
- Max output voltage: 35A
- NI200, TI, SS317/ss316/ss304 stainless steel supported
- Temp control range:212-572F
- 6ml squonk bottle included
- The oversized circle firing mechanism
- Short circuit protection
- Overcurrent protection
- Reverse polarity protection
- Under-voltage protection
- High resistance protection
- Thermal protection
- Over-voltage protection
- Low resistance protection
- Micro USB for firmware upgrades
- Squonk ready bottom feeding
- 510 thread
Features of fonte 24 RDA:
- Diameter: 24mm
- 3.5ml deep juice well
- Superior stainless steel structure
- Two post single terminal building deck
- Side-secured via hex screws
- Peek insulators
- Double O-rings top cap securement
- Dual slotted side airflow control
- Wide bore Delrin drip tip included
- Squonk 510 bottom feeding pin included
- Standard 510 thread pin included
1*spruzza 80w mod
1*fonte squonk RDA
1*single coil block crafted from heat resistant polymer
1*post Allen key
1*squonk pin Allen key
2*pre wrapped fused Clapton coils
Note: please ensure you have basic knowledge on how to properly to use it.
1)If the tanks use sub ohm coils, vapers must be sure that your device and batteries can handle sub ohm coils, only recommend experienced users order this, extra safety precautions should be practiced when using a sub ohm tank. the tank only work with the mod that can support the atomizer and coil.if you have a tank and resistance is 0.3ohm, you must sure that the mod or battery can support resistance low to 0.3ohm.improper use and lead to injury or damage.use the OHMS LAW Calculator to check.if you have question,please feel free to contact us.
2)if the coils are sub ohm coils, the user should be sure that the tank and mods can handle the sub ohm resistance coils, please make sure you have the great understanding of them, if you are not sure, please do not order and use, welcome contact us any time to get help.
3)users need pay attention to Li-ion cells when vaping.the batteries very sensitive to charging characteristics and may explode or burn if mishandled.so vapers must have enough knowledge of Li-ion batteries in charging, discharging and assembly before use. please use the fire-proof surface battery charger, never leave charging battery unattended.we will not responsible for damage for the human reason or mishandling of Li-ion batteries and chargers.the device always recommend work with rechargeable lithium-ion IMR batteries with min output current 20A or higher.
4) Smokstore will not responsible or liable for any injury, damage, defect, permanent or temporary that may be caused by the improper use of Li-ion battery, coils, tanks, mods etc.please have a basic knowledge of batteries.welcome to contact us anytime to get help.